Sirona inEos Blue, Руководство по эксплуатации, Страница: 39 / 52

63 33 632 D3446
D3446
.
201.02.03
.
23 07.2011 39
Sirona Dental Systems GmbH 11 Performing 3D acquisition
Operating Instructions Sirona Dental CAD/CAM System
Preparing an impression
1. Apply a matte finishing to the areas to be acquired to prevent
reflections. An example of a matting agent is CEREC Optispray.
2. Attach the impression tray with the filler material on the rough side of
the round plate.
3. Set the plate into the model holder with the oral side facing the
column of the inEos Blue.
Taking scans
It is best to take scans in Free Scan mode. The steps are the same as for
exposures of a model.
Tip: Be careful not to touch the impression tray when shifting the model.
Only touch the model holder.
1. Place a checkmark in front of
"Impression Scan" in the selection
dialog.
ª
Both sides of the model are displayed in the 3D preview. If you
click the
"Next" icon, the model will be reconstructed from the
impression.
2. Check the scan 3D preview. The preparation surface must be
completely scanned.
Impressions of the upper and lower jaw can only be registered via an
exposure of a corresponding buccal impression. The impression should
be matted, e.g. using CEREC Optispray, and must be positioned under
the camera so that the occlusal plane appears vertically in the live image,
and 50% of each half of the jaw is visible.