Sirocco Vola 400HE, Инструкция по установке и эксплуатации

Страница: 26 / 39

26
First Isolate the fire from the gas supply and ensure that the fire is fully cold before attempting service.

Lay out the dust sheet and tools required.

Remove the cast front fret.

Carefully remove the ceramic components

Remove the two screws that retain the tray in place and disconnect from the isolation tap.

Remove the burner tray and other components as required (i.e. remote control box)

Disconnect the gas supply, to the appliance and disconnect the isolation tap

Remove convector box by, firstly protecting the hearth from potential damage, unroll the coiled
tensioner cables from the rear of the firebox, remove the securing nipples and tensioner
adjusters, the firebox is now released from the opening and can be slid outward onto the
hearth.

Check the fireplace opening for rubble accumulation and remove, if debris is excessive, initiate
remedial work on the flue.

Check the flue with smoke pellet for correct operation.

Refit convector box using new seals where necessary

Strip off the burner pipes and clean thoroughly.

Clean out the injector, pilot assembly and burner tube. DO NOT remove the pilot injector.

Re-assemble and re-fit the burner tray.

Turn on the gas supply, and leak test.

Refit the decorative casting and ceramics.

Check any purpose provided ventilation is un-obstructed.

Light the fire and test for spillage.

Check setting pressure and safe operation of the appliance.

Remove the fire front/fret casting and place to one side.

Remove the ceramic components.

Gently clean in the open air using a dry paint brush.

Be careful not to create dust from the coals.

Where necessary replace damaged components with genuine spares.

Seal scrap ceramic components in plastic bags and dispose at proper refuse sites as directed.

Re-fit the coals by referring to the relevant section of these instructions.
SECTION 15: SERVICING
SECTION 16: CLEANING THE COALS