Sirocco Vola 400HE, Инструкция по установке и эксплуатации

Страница: 29 / 39

29
For your safety, the fire is fitted with a Flame Supervision Device (FSD), which will shut off the
Gas supply if for any reason the pilot is extinguished.
This device incorporates a fixed probe, which senses heat from the pilot burner flame, if the probe is
cooled, the device will prevent any gas flow.
If for any reason the flames go out or if the fire has been turned off for any reason, always
WAIT FOR
3 MINUTES before attempting to re-light.
The pilot is visible through the Fuel bed at the front of the fire; rotate the coals for good viewing.
Push in and turn the control knob to the SPARK position, and hold there for a few seconds.
Continue turning anti-clockwise through the spark click to the PILOT light position, ensuring that the
control knob is depressed and the pilot has lit. If not, return the knob clockwise, and repeat.

When the pilot lights after the spark, keep the knob depressed for approximately ten to fifteen
seconds.

Now release the knob and the pilot should stay alight.

If the pilot is extinguished during use, wait three minutes before repeating the ignition
procedure.

To achieve the HIGH setting, push the control knob in slightly and continue turning anti-
clockwise to the high position.

The main burner should light after a few seconds, to decrease the setting to LOW, turn the
control knob clockwise to the low setting.

To turn to the PILOT position from the HIGH or LOW positions, press the control knob in, and
return to the pilot position and release.

To turn the fire OFF, keep the control knob depressed, and return to the off position, then
release.
OF
F
IGNITIO
N
LOW
HIGH
SECTION 18.1:
OPERATING THE APPLIANCE (Manual Control)