Sirocco Streamline 3, Инструкция по установке и эксплуатации

Страница: 21 / 40

21
SECTION 15: SERVICING
Isolate the fire from the gas supply.
Ensure that the fire is fully cold before attempting service.
A suggested procedure for servicing is detailed below:
1. Lay out the dust sheet and tools required.
2. Remove the cast front fret.
3. Carefully remove the ceramic components
4. Remove the two screws that retain the tray in place and disconnect from the isolation
tap.
5. Remove the burner tray and other components as required (i.e. remote control box)
6. Disconnect the gas supply, to the appliance and disconnect the isolation tap
7. Check the fireplace opening for rubble accumulation and remove, if debris is excessive,
initiate remedial work on the flue.
8. Check the flue with smoke pellet for correct operation.
9. Strip off the burner pipes and clean thoroughly.
10. Clean out the injector, pilot assembly and burner tube. DO NOT remove the pilot
injector.
11. Re-assemble and re-fit the burner tray.
12. Turn on the gas supply, and leak test.
13. Refit the decorative casting and ceramics.
14.Check any purpose provided ventilation is un-obstructed.
15.Light the fire and test for spillage.
16.Check setting pressure and safe operation of the appliance