Sirocco Streamline 3, Инструкция по установке и эксплуатации

Страница: 29 / 40

29
Quick start user instructions
Fire Control
This control is situated on your fire. The drawing shows the main features of the control.
The control required
3 x AA size alkaline batteries to be inserted under the battery
compartment cover. The orientation of these is shown moulded into the battery compartment.
After fitting the batteries and replacing the cover the fire can now operate. Slide the slide switch
to the right to the ON position.
To start the fire, press the power button and hold for 1 second then release. The burner will
within around 1 to 2 seconds, adjust to the maximum power setting,
The power of the burner can be adjusted up and down by pressing the – or + buttons.
To stop the fire, simply press the power button again and the burner will stop.
If you are not intending to use the fire for a long period (i.e. over summer time months), the
battery life can be extended even more by sliding the white isolator switch to the left (away from
the On position).
Ensure the very small white slider switch on the front corner of Fire Control is in the
on position.
Grasp around the handset to unlock its functions. The green unlock light will
illuminate to show when the handset is unlocked and ready to accept commands.
(N.B. Keep a grip of handset to keep it unlocked, to continue to operate the command
buttons.)
For your safety, the fire is fitted with a Flame Supervision Device (FSD), which will shut off the
Gas supply if for any reason the pilot is extinguished.