Siqura MSD622, Руководство по установке, Страница: 13 / 40

Page 9
C h a p t e r 4
4 Dome Setup and Cable Connection
Before installing or connecting the MSD622, please refer to this section and complete the
preliminary preparations for setting up the dome camera and establishing switch settings.
In This Chapter
Preparing the MSD622 for Installation .................................. 9
Switch Definition ................................................................ 10
Communication Switch Configuration .................................... 10
Establishing a Network Connection ....................................... 11
System Compatibility .......................................................... 12
Dome Cable Definition and Requirements .............................. 12
4.1 Preparing the MSD622 for Installation
This preliminary installation procedure is for the MSD622 dome cameras.
Perform the following steps to prepare the dome camera for installation
1. Unpack the dome package and take out the dome body.
2. Remove the tube adaptor by rotating counter clockwise.
3. Rotate to remove the protective cover.
4. Make a note of the IP address on the label attached to the cylindrical heat sink.
5. Remove the PE cloth and take off the lens cap.
6. Generously apply the supplied lubricant to the optical cover’s waterproof boot to ensure an
IP66 quality installation.
7. Loosen the screw head alignment pins on the dome cover by turning clockwise and line up
the alignment pin and screws on the optical cover with the holes in the dome body.
8. Attach the optical cover to the dome body by pressing gently down on the sides of the dome
cover.
9. Turn the screw head alignment pins counter-clockwise with a suitable screwdriver to lock
the dome into place and secure the dome with the included Phillips-head or TORX screw.