ATTENTION!
•
Polyamide powder should be stored in tightly closed containers (e.g Sinterit Metal Container),
in a room at room temperature and low humidity.
•
The powder should be stored out of reach of children and pets.
STOP!
•
Do not attempt to burn/melt polyamide powder. The resulting sparks and hot
mass can cause severe burns.
•
Keep the polyamide powder away from fire.
ATTENTION!
Do not dispose of municipal waste! The used polyamide powder should be stored
in sealed containers and disposed of by local policy of waste plastic material.
H.
SAFETY PLATES (SPECIFICATION TAG AND SYMBOLS)
DO NOT REMOVE THIS LEBEL!
Manufacurer:
SINTERIT Sp.z o.o.
ul. Nad Drwiną 10 bud. B3, 30-741 Kraków, Poland
www.sinterit.com
Name:
POWDER HANDLING STATION
Serial number:
1234597890
Manufactured:
Made in: EU, POLAND
IEC Protection Class:
Machine type:
SLS 3D PRINTS POST-PROCESSING STATION
Class 1
Dimensions:
1000 x 700 x 1800 [mm]
39.4 x 27.6 x 70.9 [in]
IP CODE:
IP30
Total weight:
160 [kg]
Power consumption:
80-264 [V] AC, 47-63 [Hz], 6.67 [A], 80 [W]
Short-circuir current
rating
6 [A]
Warning! Read and undesrtand operator’s manual and all other safetry instuctions before using this machine.
Failure to follow operating instructions coul result in serious injury.
ATTENTION!
•
Make sure all the safety messages are legible.
•
Clean these with cloth, soap, and water. Do not use solvents, diesel fuel, or petrol.
•
Replace the damaged plates with new ones supplied by Sinterit. If a plate is attached to a
replaced part, make sure a new plate is affixed to the new part.
•
When contacting the manufacturer or dealer, always quote the details shown on the printer
plate.
WARNING!
•
Removing the safety plates on the printer is strictly forbidden!
•
The manufacturer declines all liability about printer safety in the event of failure to comply with
the above indications.
POWDER HANDLING STATION Manual | 10