Sinoboom GTJZ1412, Руководство по эксплуатации

Страница: 17 / 23

2. Take off the platform controller.
3. Remove the front two wire rope safety pins of the
extendable platform from the inside of the
platform, and fold the front failings of the
extendable platform. Hands shall not be placed
where might get hurt.
4. Fold failings at both sides, and hands shall not be
placed where might get hurt.
5. Remove the two wire rope safety pins at the rear
of the fixed platform.
6. Carefully open the door and move it onto the
ladder or floor.
7. Fold the door and right and left railings at the
entrance into one device. Hands shall not be
placed where might get hurt.
8. Fold railings at both sides. Hands shall not be
placed where might get hurt.
When using, unfold the platform railings in the
converse sequence. Use the wire rope safety pins
when unfolding railings at each side to make sure
accurate installation.
Position relationship of platform railings refers to the
Whole Vehicle Instructions.
Operate with the Controller on the Ground
It is necessary to keep safe distance between operator,
machine and fixed object.
Pay attention to the traveling direction of the machine
when using the controller.
Battery level indicator lamp
Use the diagnostic reading display on the platform to
determine the storage battery energy.
Display of electric quantity for platform Proportion
Descriptio
n
90-100%
The
battery
has been
fully
charged
70%
70% of the
battery
capacity
50%
50% of the
battery
capacity
30%
30% of the
battery
capacity
20%
The batter
level is low
and the
battery
must be
re-charged
10%
The
battery
level is
very low
and the
machine
action
becomes
slow
Charge Storage Battery

Do not use external charger.

Charge the storage battery in a well-ventilated
place.

Charge with the correct AC input voltage
indicated on the label.
1. Make sure the storage battery is well connected
before charging.
2. Remove the storage battery ventilation cover.
3. Check the acid liquid level of the storage battery.
If necessary, replenish the distilled water through
the filling pipe at the top of the storage battery.
Add only enough distilled water to cover the
plate and do not overdo it during charging.
4. Install the ventilation cover.
5. Connect the storage battery charger to the
grounded AC circuit.
6. The charger will give instructions when the
storage battery is charged fully.
7. Check the storage battery acid level at the end of
charging cycle. Add distilled water to the bottom
of the filling tube. Do not overdo it.
16
GTJZ1412 & GTJZ1414
Operation Manual