Sindoh A610 Series, Руководство по обслуживанию

Страница: 170 / 218

166
Output Bin Stack Full
Error
Occurs when the output bin is full.
1. Remove paper from output bin.
Paper Empty: T1 Occurs when a job is sent to tray 1 when it is empty.(Main tray)
4. Check Tray1 Empty Sensor flag status.
5. Check if Tray1 Empty Sensor is working.
6. If not, replace sensor and test again.
Paper Empty: T2 Occurs when a job is sent to tray 2 when it is empty (Optional
tray).
1. Check Tray2 Empty Sensor flag status.
2. Check if Tray2 Empty Sensor is working.
3. If not, replace sensor and test again.
Message Description
Paper Empty: T3 Occurs when a job is sent to tray 3 when it is empty (Optional
tray).
1. Check Tray3 Empty Sensor flag status.
2. Check if Tray3 Empty Sensor is working.
If not, replace sensor and test again.
Paper Empty: MPT Occurs when a job is sent to MPT when it is empty.
1. Check MPT Empty Sensor flag status.
2. Check if MPT Empty Sensor is working.
3. If not, replace sensor and test again.
100 MPT Miss Feed
Jam Occurs when paper fails to reach the entrance sensor within set
time after being picked up from MPT.
(Although 100 MPT Miss Feed Jam message is displayed, if MPT
has failed to pick up paper there may not be a paper jam in the
path.)
1. Check whether paper has been properly loaded in the
tray (check tray guide condition).
2. Check whether the tray has not been overloaded.
3. Check paper condition (whether it has been damaged)
4. Check whether paper path between tray and entrance
sensor is clear.
5. Check whether the pickup solenoid is working.
6. If not, replace the solenoid and test again.
7. Check whether the entrance sensor is working
(Diagnosis mode)
8. If not, replace sensor and test again.
101 Tray1 Miss
Feed Jam Occurs when paper fails to reach the entrance sensor within set
time after being picked up from main tray.
(Although 101 Tray1 Miss Feed Jam message is displayed, if
Tray 1 has failed to pick up paper there may not be a paper
jam in the path.)
1. Check whether paper has been properly loaded in the
tray (check tray guide condition).
2. Check whether the tray has not been overloaded.
3. Check paper condition (whether it has been damaged)
4. Check whether paper path between tray and entrance
sensor is clear.
5. Check whether the Pickup DC motor is working.
6. If not, replace the DC motor and test again.
9. Check whether the entrance sensor is working
(Diagnosis mode)
7. If not, replace sensor and test again.