Sinclair SCV EB Series, Инструкция по установке и эксплуатации

Страница: 20 / 52

CN83:COMP-STATE,connect with an ac light to indicate the state of the compressor
Attention: the control port value of the pump actually detected is ON/OFF but not 220-230V control power supply
，
so
special attention should be paid when installing the light.
CN85
：
The alarm signal output of the unit(ON/OFF signal)
Attention: the control port value of the pump actually detected is ON/OFF but not 220-230V control power supply
，
so
special attention should be paid when installing the alarm signal output.
CN52:Fan realy driver port. (Only for MC-SU60-RN8L )
NO.
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
Detail information
CN2:HEAT1.Pipeline Auxiliary Heater
Attention: the control port value of the pump actually detected is ON/OFF but not 220-230V control power supply
，
so
special attention should be paid when installing the pipeline auxiliary heater.
CN20:TP-PRO,Discharge temperature switch protection (protection code P0,provent the compressor from
over temperature 115
℃
)
CN70:EXVA,System electronic expansion valve1.
CN61:Outdoor units communication or HMI conmunication port
CN60:Outdoor units communication or HMI conmunication port
CN64:Fan inverter module communication ports
CN65: Compressor inverter module communication ports
CN300:Program burn in port(WizPro200RS programming device).
IC10:EEPROM chip
CN1:temperature sensors input port.
T4: outdoor ambient temperature sensor
T3A/T3B:pipe temperature sensor of the condenser
T5:wtater tank temperature sensor
T6A:Refrigerant inlet temperature of EVI plate heat exchanger
T6B:Refrigerant inlet temperature of EVI plate heat exchanger
CN16:System pressure sensor
CN31:Temperature sensors input port
Th:System suction temperature sensor
Taf2:Water side antifreeze temperature sensor
Two:Unit water outlet temperature sensor
Twi:Unit water inlet temperature sensor
Tw:Total water outlet temperature sensor when several units are connected in parallel
CN3:Module 1 temperature sensor
CN10:Module 2 temperature sensor
CN15:Detection of current of the compressor system input port
INV1
：
Detection of current of the compressor A
INV2
：
Detection of current of the compressor B
CN69:Temperature sensors input port
Tp1
:
DC inverter compressor 1 discharge temperature sensor
Tp2:DC inverter compressor 2 discharge temperature sensor
Tz/7:coil final outlet temperature sensor
Taf1:Water side antifreeze temperature
CN19:Low voltage protection switch.(Protection code P1)
CN91:Three-phase protector output switch.(Protection code E8)
CN58:Fan realy driver port.
SW3:Up button
a) Select different menus when enter menu selection.
b) For sopt inspection in conditions.
SW4:Down button
a) Select different menus when enter menu selection.
b) For sopt inspection in conditions.
SW5:Menu button
Press to enter menu selection, short press to return to the previous menu.
SW6:OK button
Enter the submenu or confirm the function selected by short pressing.
CN8:Remote function of cool/heat signal
CN8:Remote function of on/off signal
15