ES
5/8
PUESTA EN MODO REPOSO/REANUDACIÓN DEL MOTOR
4
i
Es posible poner la radio del motor en modo reposo para:
- limitar la descarga de la batería durante los periodos en los que el panel solar no puede funcionar nor-
malmente (embalaje de la persiana enrollable, transporte, almacenamiento, etc.).
- impedir cualquier riesgo por maniobra imprevista. (transporte, almacenamiento, etc.).
Después de colocar la persiana enrollable, bastará con reanudar el motor para seguir con la pro-
gramación de los otros puntos de control.
4.1 Puesta en modo reposo de la radio del motor:
i
Solo es posible activar el modo reposo después de haber registrado el primer punto de control en el §3
y antes de haber realizado las programaciones del §5 (durante 10 minutos como máximo, o durante los
10 minutos posteriores a un corte de alimentación desde la batería y del panel solar de forma simultánea).
- Pulse simultáneamente
las teclas
“subida”, “stop” y
“bajada”
del emisor (programado en el §3)
durante más de
tres segundos.
El motor efectúa una rotación de 0,5 segundos
en un sentido y luego en el otro. La radio del motor está en
modo reposo.
4.2 Reanudación de la radio del motor:
i
La reanudación del motor solo es posible si el panel solar está conectado al motor y está iluminado (luz
difusa del sol, linterna, etc.).
- Pulse simultáneamente las teclas
“Subida” y “Descenso”
durante
10 segundos.
El motor efectúa una rotación de 0,5 segundo en un
sentido y luego en el otro.
El motor se encontrará de nuevo funcional.
>>
> 3 s
>>
10 s
PROGRAMACIÓN DE UN NUEVO PUNTO DE MANDO (INDIVIDUAL, GRUPO O GENERAL)
5
5.1- Abrir la memoria del motor desde el emisor de
accionamiento individual :
- Pulsar aproximadamente
3 segundos
en la tecla
PROG
del emisor de accionamiento individual. El
motor gira 0,5 segundo en un sentido y luego en otro.
5.2- Validar la operación desde el nuevo emisor a
programar:
- Pulsar
1 segundo
aproximadamente en la tecla
PROG
del nuevo emisor. El motor gira 0,5 segundo en
un sentido y luego en otro.
- Si el nuevo punto de mando es un emisor de grupo: repetir las operaciones
5.1 y 5.2. para cada motor del
grupo.
- Si el nuevo punto de mando es un emisor general: repetir las operaciones
5.1 y 5.2 para cada motor de la
instalación.
- Para suprimir un emisor de la memoria del motor: efectuar las operaciones
5.1 desde el emisor de mando
individual y la operación 5.2 desde el emisor a suprimir.
1
>>
PROG ≥ 3 s
>>
PROG < 1 s
2