Contents
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communication. However, there is no guarantee that interference
will not occur in a particular installlation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●
Consult the dealer or an experienced radio / TV technician for help.
FCC WARNING
Changes or modification not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Akustischer Geräuschpegel
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Dieser Druckerüberschreitet einen Ger
ä
uschpegel von 70 dB (A) w
ä
hrend dem Betrieb nicht.
Summary of Contents for MP7080A
Page 7: ...fig1 1 Check 2 Recording surface fig2 1 50 to 100mm Back ...
Page 20: ...3 Load the disc by pressing the eject button or by lightly pushing in the disc tray ...
Page 21: ...Next Load the disc Disc ejection Emergency Eject Using the Drive in a Vertical Position ...
Page 31: ...To Install as a Slave Drive ...
