Simrad TV45, Руководство пользователя

Страница: 15 / 176

Simrad Marine TV English-15
3. TV operation
Press the power key to turn on the control unit. The display shows
Init
for ini-
tialization. After the initialization is completed, the display interchanges between
scanning
and
Sat
X (X is the last shown storage position) until the satellite
has been located. The system will now run a check on the satellite:
checking
.
If o.k., the display will briefly indicate
complete
and then return to Sat X.
The antenna willl maintain its connection to the satellite even when the boat is
moving. (Providing that the tracking function is active, see section 2.4).
If you wish to select a different satellite, press repeatedly until the desired
satellite position appears, and then confirm with
If no satellites are stored, the display will show
Setup
(flashing).
You are now back in the main menu and can add new satellites (see sec.4.1).
If the search for a new satellite takes more than 1 minute, even though there is
a clear view to the satellite, or if, after several times finding the right satel-
lite, the display shows
upd reco
and interchanging with the actual satellite
number, then the satellite data base has to be updated, see section 4.2.
If there is no picture on the TV after the satellite has been checked and found
o.k., there are two possibilities:
1.
The satellite service provider has changed the transponders or it is the
wrong satellite. In order to proof the right satellite has been found, try to
switch to other programs on the receiver. If all other programs are in their
usual places, you need to reprogram your receiver for the program which
have changed. Please refer to the manual of the receiver.
2.
US only: In case that no program can be received, try to turn off the Fast-
scan function, see section 5.4.
When changes are made, return to
Sat
X and press to start a new search.
If the search for a new satellite takes longer than 4 minutes and after some time
the display shows
Sat ok ?
, then the requested satellite could not be found.
All available satellites will be presented and the operator can choose one.
Make sure the receiver is switched to a program from this satellite, so the
correct satellite can be identified. If the display shows
Sat ok ?
and there is
no picture on the TV, press to continue the search. This has to be repeated,
until the TV shows the correct program. Press
to confirm.
The display will now interchange between
Sat
X and
UpDate ?
. Press to
update the satellite data base. The display will flash:
updating
, and shortly