If you have a set top Freeview™ receiver, VCR or PVR the aerial connection will be to the ANT. IN coaxial socket
of the device which will then be connected to your TV (usually via a SCART lead). If you have a TV with a built-in
Freeview™ receiver the connection will be to the ANT. IN coaxial socket on your TV.
1. Switch off your set top box/
TV power.
2. Connect the right angle
coax plug end of the
Aerial
Coax Lead
to the socket on
the base of your aerial stand
and the other end into the
Coax Power Adaptor
.
3. Plug the
Coax Power Adaptor
into the aerial (ANT. IN) socket
on your set top box/TV.
4. Plug the PSU into a mains socket.
5. Switch on your PSU, set top box
and TV.
6. Adjust the position of your aerial
for optimum signal reception.
Ultra Thin Amplified Digital TV Aerial
USER GUIDE
Aerial Assembly / Installation
27776R
Philex Customer Careline: 08457 573479
•
High performance compact aerial
•
Can be wall mounted or free standing
•
Ideal for receiving strong digital and analogue TV signals
RF Aerial Flylead - not supplied
(only use if analogue signal required*)
SCART Lead
(not supplied)
Freeview™
Box/PVR
TV
PSU - Plugs into
Mains Socket
Coax Power Adaptor - Plugs
into ANT. IN (Plugs directly
into TV ANT. IN if TV has
built-in Freeview™ receiver)
Aerial Coax Lead - Plugs
into Coax Power Adaptor
Ultra Thin Digital Aerial
To assemble your aerial unfold the white plastic folded element
and slide the end with three square indents into the stand as
shown opposite.
The side with the circles at the centre should face to the front/
curved side of the stand. The aerial can now be placed on a TV set
top or suitable flat surface close to your TV. Alternatively the aerial
can be wall mounted using the key slots on the back of the stand.
Wall Mounting
If you decide to wall mount your aerial, choose fixings - screws, wall
plugs etc. (not supplied) suitable for attaching your aerial to the
surface chosen, make sure the screw heads will fit the key slots on
the aerial and hold it firmly in place.
1. Follow the connection instructions below and check that reception is
good in the position you have chosen by holding the aerial in place.
2. Place two screws into the mounting surface with the heads protruding
just enough to hold the aerial in place when they are located in the
key slots. The centre of the heads should be 72mm apart and level.
Aerial Connection
Key Slots
Square
Indent
