Chapter 3: Configure the IPMI port for remote management
27
Chapter 3: Configure the IPMI port for remote
management
This section contains the following topics:
•
Connect to IPMI and launch the Virtual Console
•
IPMI configuration requirements
You configure the integrated Intelligent Platform Management Interface ( IPMI) port to access the IPMI
console through a web browser. The IPMI console provides out-of-band remote system management
and access to advanced management options.
Before you begin
Your environment meets the requirements for configuring IPMI. See
IPMI configuration requirements
on
page 29.
Procedure overview
This procedure assumes you are using a computer with Microsoft Windows. If you prefer to configure
IPMI at a later time, you can skip this task and proceed with deploying an OmniCube host using
Deployment Manager. See the
SimpliVity OmniStack Host Deployment Guide
.
Procedure
1.
Connect an Ethernet cable from the Ethernet port on the laptop to the IPMI Ethernet port on the
rear of the OmniCube server.
2.
If necessary, change the IPv4 address of the Ethernet port on your laptop:
a) Open
Network and Sharing Center
and select the Ethernet port connection. This is typically
Local Area Connection
.
b) Click
Properties
>
Internet Protocol Version 4 (TCP/IPv4)
.
c) Record the current settings so that you can restore them later.
d) Check the button labeled
Use the following IP address
.
e) Enter an IP address in the range 192.168.0.[0-255], excluding 192.168.0.120.
f) Enter a subnet mask of 255.255.255.0.
g) Close the dialogs and exit from
Network and Sharing Center
.
3.
Point your browser to the IPMI default IP address: http://192.168.0.120
4.
4. Use the default user name
root
and the default password
calvin
to log in.