REV020620
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 |
| 9 |
The BOSS.6 is not suited for wall mounting. Any attempt to wall-mount the BOSS.6 Enclosure will Void the
Warranty.
Six 1-inch knockouts are located in the base and mounting feet of the BOSS.6 for tool accessibility when
mounting the BOSS.6 to a concrete pad. Cover knockout holes with sealing tape after pad mount
installation, and prior to installing the PHI Batteries into the base of the cabinet. Failure to seal the
knockout holes will Void the warranty.
Secure the BOSS.6 to the concrete with concrete anchors, such as threaded rods, masonry bolts, or
carriage bolts, minimum ½” diameter.
3.3 – Assembling the BOSS.6 Enclosure
4.
Make sure all PHI battery module circuit breakers are in the “OFF” position. Prepare the battery
modules for installation by removing all plastic terminal covers, 11/16” stainless steel hex nuts and
3/8” lock washers from the batteries’ terminals and set aside.
CAUTION: Do not attempt to loosen the large brass nut at the base of the battery
terminals. Doing so will Void the Warranty
5.
Install the battery modules in the Enclosure starting at the bottom of the Enclosure.
6.
Arrange up to three battery modules on each shelf. Orient the modules so that the battery terminals
point forward toward the door, with the positive posts nearest the bottom of the Enclosure.
Illustrations shown are for six batteries per unit.
Figure 2 –6 PHI Battery Module Arrangement within the Enclosure
Содержание BOSS.6
Страница 1: ...SIMPLIPHI POWER INC REV020620...