7
Item #
Part Name
Qty.
Illustration / Part #
F
5-in-1 project
dial
1
XE18-020-0001
G
Cleaning
needle
1
—
H
Foam blaster
1 set
XE18-060-0000
*Handle crank, high-pressure hose and water filter come
pre-attached on the machine.
5. a
ssembly
I
nstructIons
5.1 Water Supply (Cold Water Only)
Only draw water through the unit. The device must be used
with cold water supply only. The water hose must be at least
1/2” (13 mm) in diameter. The water flow rate must not fall below
2 gal/min (9.1 L/min). The flow rate can be determined by running
water for one minute into an empty container. The water supply
temperature must not exceed 104ºF (40ºC).
5.2 Safety Advice
CAUTION
•
Never use the pressure washer to draw in water
contaminated with solvents (e.g. paint thinners,
gasoline, oil, etc.).
•
Dirt in the water inlet will damage the unit. To avoid this
risk, we recommend checking the water filter (located
inside the water inlet). To clean it out, refer to the
Cleaning and Maintenance section.
•
Always prevent debris from being drawn into the unit by
using a clean water source and an additional accessory
water filter, if required.
•
To prolong the life of the unit, let it rest for 5 minutes
after every 30 minutes of use.
•
Check to make sure you have all the parts.
•
Remove any objects from the work area that could be a
hazard or tripped over, such as toys or outdoor furniture.
•
Ensure that all doors and windows are closed tightly.
5.3 Accessories Storage Locations
a
s
d
Assembly Instructions
Foam
blaster
5-in-1
project dial
Gun and
wand
Cleaning
needle
Cord hook
Cord hook
S2000-Washer-EN-01.indd 7
2015-01-13 3:10 PM
