Unpacking the Screen
1. Remove all the items from box. Don’t cut the boxes too deep,
as this may damage the screen.
(FIG 1)
Infl ating the screen
1. Remove the frame from the package. Unroll the
screen as shown at right. Be sure both bases are
facing the correct way. (Both air valves should be
facing the same direction.)
(FIG. 2)
2. Plug the AC air pump into an AC power outlet.
NOTE:
POWER SUPPLY MUST BE 120V AC, 60 Hz. USE A
PROPERLY GROUNDED GFI OUTLET IF USING THE
PRODUCT OUTDOORS
3. Locate the air inlet/outlet valves. You will notice that
each valve on each base has two layers of seals that
cut off the airfl ow. The outer seal is a threaded cap
that screws into place.
(FIG. 3)
4. The inner seal is a rubber check valve designed to
hold in air when a certain amount of pressure is applied.
(FIG. 4)
FIG 1
FIG 2
FIG 3
FIG 4
Page 5