Wrinkles & Creases in the screen
Note: Some wrinkles are normal and will not
aff ect the viewing image.
The Frame is defl ating over time
Note: If the frame is left infl ated overnight
during a moderate temperature change the
frame will show a loss of air pressure. Be sure
to defl ate frame and store after usage.
Video is not bright enough on the screen
Part of the picture is missing viewing in the
rear projection position.
1. Remove the screen prior to defl ating and roll it back
up for storage.
2. Setup the screen and frame in a warm environment
(Sunlight) to remove the wrinkles from the screen.
1. Be sure to remove the air pump hose after infl ating.
Air can leak back through the pump if not removed.
2. Check the inner rubber air valves are seated properly
prior to closing outer threaded cap.
3. Listen for air holes in the frame around the seams.
You may use mild soap and water to locate the leak.
1. Use a projector with enough lumens to better view
your video for certain indoor / outdoor conditions.
1. Place the projector on a stand so its height is
centered in the screen.
PROBLEM
SOLUTION
Page 12
Troubleshooting Guide