Silvercrest SFW 350 D3, Руководство по эксплуатации

Страница: 36 / 166

SFW 350 D3
GB
│
IE
│ 33 ■
7) Replace the pattern strips
1
back in to the front of the biscuit attachment
1
.
Ensure that the grip on the pattern strips
1
points away from the appliance .
If it does not, you will not be able to adjust the pattern, which is located
directly on the grip .
8) Assemble the meat grinder casing
6
as described under “Assembling the
meat grinder” .
9) To dismantle it, you must first remove the pattern strips
1
before you can
screw the ring clamp
t
open and take the biscuit attachment
1
back out .
Fitting the strainer attachment
Unfold the fold-out page – it contains the step-by-step illustrations for assembling
the appliance .
1) Remove the meat grinder casing
6
as described in “Assembling the meat
grinder” .
2) Remove any attachments that might be fitted and clean the meat grinder
casing
6
.
NOTE
► The transport screw
q
and the cross blade
e
with the spring
w
are not
required for the strainer attachment! Remove these from the meat grinder
casing
6
if necessary .
3) Push the plastic screw
9
into the meat grinder casing
6
.
4) Push the strainer sieve
0
over the plastic screw
9
so that the tabs on the
strainer sieve
0
fit into the recesses in the meat grinder casing
6
. The holes
of the strainer sieve
0
should be facing downwards .
5) Once everything has been correctly attached, roll the ring clamp
t
over the
strainer sieve
0
and screw it on hand-tight .
6) Fit the meat grinder casing
6
as described in “Assembling the meat grinder” .
7) Undo the locking clamp
7
on the tomato outlet
8
.
8) Place the tomato outlet
8
under the strainer sieve by pushing the tip of the
strainer sieve
0
through the small hole in the tomato outlet
8
:
IB_314659_SFW350D3_LB8.indb 33 21.01.19 14:53