62 GB
10.5 End cooking
1. End the cooking program or the warm
program by pressing the Cancel button
Keep Warm/Cancel
37
.
The display
29
shows
OFF
. The device
is in standby mode.
2. Pull the mains plug
11
out of the wall
socket.
3. Select a suitable method for reducing
the pressure in the pot and safely open-
ing the lid
5
(see “Opening lid safely
(while hot)” on page 57).
4. Remove the hot pot
7
using potholders
or oven gloves.
5. Allow the device to cool down before
you clean it.
10.6 Warm (Keep Warm/
Cancel)
When a cooking program has ended, the
device automatically switches to the warm
program
Keep Warm/Cancel
37
.
You can also start the warm program manu-
ally in order to keep hot food warm in the
Multi-Pot.
NOTES:
• Keeping food warm for very long peri-
ods changes the flavour and appear-
ance, vitamins are destroyed, and the
food can go bad.
• Because the warm program works with-
out pressure, you can open and close
the lid
5
while the program is running.
You should however be aware of any
residual pressure that may be present af-
ter another cooking program.
• After the yoghurt program (
Yogurt
43
),
the device does not automatically switch
to the warm program.
1. Place the hot food into the pot
7
.
2. Wipe down the outside of the pot
7
if
necessary. It must be clean and dry.
3. Place the pot
7
into the base unit
13
.
4. Place the lid
5
and lock it, such that the
arrow marking
6
points to the
marking
9
. The locking mecha-
nism will click audibly.
5. Open the pressure valve
1
by pressing
down on the pressure valve button
2
until it clicks into place.
6. Use the mains power cable
11
to con-
nect the port
14
on the base unit
13
to
a properly installed earthed wall socket
that corresponds to the technical data.
7. As soon as the device is connected to
the power supply, the display
29
will
show
OFF.
The device is in standby
mode.
8. Click the Cancel button
Keep Warm/
Cancel
37
to start the warm program.
The LED of the Cancel button
Keep
Warm/Cancel
37
is lit. The dis-
play
29
counts the warm time upwards
from
00:00.
After 12 hours, the warm program ends
automatically.
9. Click the Cancel button again to end
the warm program
Keep Warm/
Cancel
37
.
The LED of the Cancel button
Keep
Warm/Cancel
37
goes out. The dis-
play
29
will show
OFF
. The device is in
standby mode.
10. Pull the mains plug
11
out of the wall
socket.
11. Open the lid
5
and place it in the drip
dry position (see “Placing lid in drip-dry
position” on page 55).
12. Remove the hot pot
7
using potholders
or oven gloves.
13. Allow the device to cool down before
you clean it.
__367792_2101_Schnellkochtopf_CY.book Seite 62 Mittwoch, 9. Juni 2021 10:18 10