Silvercrest 316620, Руководство по эксплуатации

Страница: 13 / 25

11 GB
7. Before first use
• Clean the device prior to its first use (see
“Cleaning and storage” on page 20)!
• Remove the protective film from the operating pan-
el | 10 .
NOTE: because the device is slightly greased when deliv-
ered, slight smoke and odour may be produced during its
first use. This is harmless and stops after a short amount of
time. Please ensure sufficient ventilation in the meantime.
8. Handling of the Multi-Pot
8.1 Opening lid (when cold)
Figure B:
1. Hold down the release button | 24 while you turn the
lid | 5 clockwise until the arrow marking | 6 points to
the marking | 19 .
2. Remove the lid | 5 upwards.
8.2 Placing lid in drip-dry position
Figure C: for example to drip-dry the hot lid, you can
place the lid | 5 upright with the tab | 4 in the recess in one
of the handles | 20 of the base unit | 17 .
8.3 Closing lid
Figure D:
For pressure to be able to build up in the Multi-Pot, it is im-
portant that the lid
| 5 is closed correctly.
1. Place the lid | 5 with the arrow marking
T
| 6 pointing
to the marking | 19 .
2. Turn the lid | 5 anticlockwise until the arrow
marking
T
| 6 points to the marking | 9 . The lock-
ing mechanism will click audibly.
NOTE: when the lid | 5 is on top of the base unit but not
correctly closed, signal sounds will be heard and the dis-
play
| 29 will show Lid .
8.4 Opening/closing pressure valve
DANGER! Risk of injury from scalding!
~
Ensure that no body parts (e.g. hand or arm) are
above the pressure valve
| 1 when you open this using
the pressure valve button | 2 and steam escapes.
There is a danger of being scalded by escaping
steam.
The pressure valve button | 2 allows you to open and
close the pressure valve | 1 .
8.5 Pressure indicator
DANGER! Risk of injury from scalding!
~
Before each use, you must check to ensure that the un-
derside of the pressure indicator
| 27 is clean and
moves freely (see “Preparations before each use” on
page 13).
~
Ensure that no body parts (e.g. hand or arm) are
above the pressure indicator
| 23 when steam escapes
from it.
The pressure indicator | 23 is a valve located in a recess in
the lid | 5 . Hot steam can flow out of this valve when pres-
sure has built up inside the Multi-Pot. You can see that the
Multi-Pot is pressurised when the pressure indicator
| 23 is
lifted.
Opening Closing
• Press down the pressure
valve button | 2 until it
clicks into place.
• Press down the pressure
valve button | 2 so
that it disengages.