Silvercrest 306411, Инструкция по эксплуатации и правила безопасности, Страница: 54 / 200

GB
│
IE │
51 ■
SCUR 3 A1
Troubleshooting
This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.
Fault causes and remedies
The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section "Service").
Fault Possible cause Remedy
There is nothing on
the display
.
The mains cable
%
is not
plugged in.
Insert the plug of the mains cable
%
in the mains socket.
The power socket is not
supplying power. Check the house fuses.
No sound.
The volume is set to mini-
mum. Turn the −VOL+ / І◄◄ TUNE ►►І
dial to the right to increase the
volume.
The device is in standby
mode.
Press the / SOURCE button
0
to
switch on the device.
Interference with the
radio reception.
The reception is weak.
Try to improve reception by moving
the wire aerial
,
.
Use the ■ ST / MONO button to
switch to mono playback.
The CD is not
played.
It is an incompatible CD-R
or CD-RW. Swap the CD for another (audio)
CD.
The CD is the wrong way
up in the CD compartment
.
Place the CD, with the printed side
facing up, into the CD compartment
.
The time and station
presets are lost after
a power failure.
No batteries in the battery
compartment
+
or batter-
ies are dead.
Check that the batteries are suffi-
ciently charged and replace them if
necessary.
The batteries are inserted
incorrectly in the battery
compartment
+
.
Check whether the batteries are
inserted the right way round in the
battery compartment
+
. Note
the polarity diagram in the battery
compartment
+ .