Silvercrest 306411, Инструкция по эксплуатации и правила безопасности

Страница: 45 / 200

■ 42
│ GB
│
IE
SCUR 3 A1
Connecting headphones
♦ Turn the −VOL+ / І◄◄ TUNE ►►І dial to the left to the lowest volume.
♦ Insert the jack plug on the headphones into the headphone socket
!
on the front of the device. Sound playback now takes place only via the
connected headphones.
♦ Set the desired volume with the −VOL+ / І◄◄ TUNE ►►І dial .
Radio
Automatic station search (AMS)
NOTE
► This device must be switched on. Press the / SOURCE button
0
,
if necessary, to switch on the device.
► The wire aerial
,
must be unwound.
♦ Press the /
SOURCE
button
0
briefly until "FM" and the frequency
display is shown on the display .
♦ Press the ►/ II / SCAN / AMS button to start the automatic station search.
The station search works in both directions. This is dependent on the last-
used manual search direction. The station search stops at the next station
with a sufficiently strong signal.
Storing stations automatically
The automatic station search with station saving scans once through the entire
frequency band and automatically saves the first 20 stations with a sufficiently
strong signal in the programme spaces 1–20.
♦ Press the ►/ II / SCAN / AMS button for longer than 2 seconds to start
the automatic station search with station saving. The first 20 stations will
be saved in the programme spaces 1–20 in order of increasing frequency.
After the station search is complete, the station stored in the first programme
space is played automatically.
NOTE
► The automatic station search replaces the stations already stored in the
programme spaces.
Manual station selection
♦ Press −VOL+ / І◄◄ TUNE ►►І dial once and turn it to the left or right to
change the frequency in steps of 0.05 MHz. The current frequency is shown
on the display
.
♦ Press the −VOL+ / І◄◄ TUNE ►►І dial again or wait at least 10 sec-