GB
│
IE
│
NI
│
CY
│
9
■
SEMK 105 A1
Operation and use
Filling the appliance
CAUTION – PROPERTY DAMAGE!
►
Never fill hot water into the water tank ! The water temperature should
be between 8 and 25°C .
NOTE
►
Before filling the appliance, make sure that the cap is firmly in the drain
opening on the underside of the appliance . Otherwise, the filled water
will flow straight out again .
♦
Open the lid and take out the ice basket .
♦
Use a container such as a measuring cup to fill the water tank .
Never exceed the MAX marking .
♦
Replace the ice basket in the appliance and close the lid .
Starting ice production
WARNING
►
Always use fresh drinking water to prepare ice cubes . Never reuse the
water from thawed ice cubes!
♦
Press the
button to start ice production .
The control lamp lights up permanently green .
♦
After around 7–15 minutes, depending on the water and ambient tempera-
ture, you will hear ice cubes start to fall into the ice basket .
To remove ice cubes, open the lid and remove the required amount of
ice cubes using the ice scoop . Then close the lid again .
♦
If the "Ice full" lamp
lights up red, the ice basket is full . Ice cube
production is stopped and the appliance stops cooling . As soon as you
have removed enough ice cubes, the appliance will resume production .
♦
If the "Add water" lamp lights up red, the water fill level is too low . Ice
cube production is interrupted and the appliance stops cooling . If you want
to continue producing ice cubes, fill the water tank as described in the
section "Filling the appliance" .
Содержание 296909
Страница 3: ...A B C ...