Silicon Laboratories ZigBee RD-0001-0201, Руководство пользователя

Страница: 10 / 13

6. Utilities
6.1 Transfer Files to and from the Gateway
Once connected to the Gateway Wi-Fi access point, it is possible to transfer files to the Gateway:
1. Open WinSCP .
2. Connect to the Gateway at 192.168.42.1, port 22.
3. Login =
pi
; Password =
raspberry
6.2 Remote Login to the Gateway
Once connected to the Gateway Wi-Fi access point, it is possible to login remotely.
1. Open an SSH session using PuTTY .
2. Connect to the Gateway at 192.168.42.1, port 22.
3. Login =
pi
; Password =
raspberry
6.3 Change Wi-Fi Parameters
The Wi-Fi parameters can be changed by modifying the "hostapd.conf" file.
cd/etc/hostapd
sudo nano hostapd.conf
1. Change the Wi-Fi parameters such as SSID and/or wpa_passphrase.
2. Press CTRL+X to exit.
3. Press "Y" to write changes.
4. Type "Enter" to accept.
sudo reboot
6.4 OTA (over-the-air) Firmware Update
OTA firmware updates for the contact sensor, lighting demo board and dimmer switch is possible if update files are located here: /opt/
SiliconLabsGateway/webserver/ota_avail_files . OTA files in this location will appear in the “Available OTA images list” as described in
Section 3.2 Home . The OTA update process will take approximately ten minutes for non-sleepy devices and up to several hours for
sleepy devices. Only one device should be in the "Attached Devices" list prior to beginning the OTA update process.
UG131: ZigBee
®
Wi-Fi/Ethernet Gateway Reference Design (RD-0001-0201) User's Guide
Utilities
silabs.com | Smart. Connected. Energy-friendly. Rev. 0.3 | 9