34
Chapter 3: Fibre Channel Hub Setup and Cabling
Connecting the Hub Power Cord and Powering On the Loop
Follow these steps:
1.
Connect the Fibre Channel Hub power cord(s) to a power source.
2. Turn on the Fibre Channel Hub power switch(es). On the hub(s):
The green power LED at the top left of the Ethernet port should illuminate.
The yellow LED at the bottom left of the Ethernet port should illuminate, indicating
network activity.
The LED for each port should be
•
yellow if the device cabled to it is not yet powered on, indicating that the port is
not participating in the loop (bypassed)
•
green if the device cabled to it is powered on
Figure 3-7 shows LED locations.
Figure 3-7
Hub LEDs
1
6
2
7
3
8
4
9
5
10
REAR
Console
10BaseT
FC port LEDs
Power LED
FC port LEDs
LEDs for two FC ports (5 and 10) on rear
Network LED
