Silent Venus SVP600, Установка и обслуживание

Страница: 9 / 26

SEWER PIPE CONNECTION
Using a 1 1/2-inch branch hub, install a standard wye fitting connecting the
discharge pipe to a sewer pipe.
If the discharge pipe is made of copper, purchase a brass male adapter
((MPT x Hub) 3/4" x 3/4" sweat) for the subsequent steps. If it is a CPVC pipe,
then a CPVC male adapter ((MPT x Hub) 3/4" x 3/4" sweat) is recommended.
If the wye fitting is made of copper, solder a length of pipe to the adapter
and allow it to cool. The cooling process can be accelerated if a wet rag is
wound around the plastic during soldering. For effective soldering and to
prevent the plastic material from deteriorating, a minimum distance of 6
inches must be maintained between the plastic and the piece being
soldered, and Teflon tape or 100% Teflon dope on male thread must be used.
Once the soldered piece has cooled, screw it into a female bushing
((spigot x FPT) 1 1/2" x 3/4"). Then glue the bushing into the 1 1/2" branch hub
of the wye fitting.
If the wye fitting is made of cast iron, PVC, CPVC or ABS, screw your male
adapter into a female bushing ((spigot x FPT) 1 1/2" x 3/4") and glue the
bushing into the 1 1/2" branch hub of the wye fitting.
Caution: Do not use ABS glue to join any CPVC material, as the glue would
fail to properly bond the materials.
PROPER DISPOSAL
The unit is designed to give many troubled free years of service, however, at
the end of its life be advised that the unit meets the current directive for
disposal and must be handled in accordance with these standards.
7