Silent Gliss Move, Оригинальная инструкция по эксплуатации

Страница: 17 / 43

17 | EN
1. Switch off the backup, wait several seconds, and then
switch it back on if the receivers are already connected
to the power supply. The receiver will then remain in
configuration mode for around 5 minutes.
2. Hold the STOP button on the Move Transmitter Stick
for approximately 1 second. The shutters/blinds will
then automatically move downwards and then upwards
for roughly 2 minutes to indicate that the receiver is in
configuration mode.
3. Press the OPEN button to immediately acknowledge (no
later than after 1 second) when the shutters/blinds start
to rise. The status display lights up briefly. The shutters/
blinds stop – resume movement – stop – and then move
toward the CLOSED position.
4. Press the CLOSE button to immediately acknowledge
(no later than after 1 second) when the shutters/blinds
start to descend. The status display lights up briefly. The
shutters/blinds stop.
Important:
You must repeat the configuration process if the shutters/
blinds do not stop.
The receiver is configured on the selected channel of the
Move Transmitter Stick.
The Move Server receives the information concerning the
devices configured on the Move Transmitter Stick immedi -
ately after the stick is inserted in the Move Server.
This must be considered especially if the Move Server is
used as a power supply unit during the Move Transmitter
Stick configuration process.