EtherHaul™ 8000 Installation, Operation and Maintenance Manual
Page 17
2
Installing the Radio Link
This chapter describes how to install and perform the basic setup of a radio link,
including:
Preparing the site
Package content
Unpacking the radio
Required tools
Preparing for installation
Installing the Radio
o
With 0.5ft/1ft antenna
o
With 2ft antenna
Connecting the cables
System LEDs
Aligning the antenna
Link up verification
The installation of the radio link should be followed by initial system setup that will be
described in the next chapter.
Caution:
The installation and maintenance of the radios should only be done by service
personnel who are properly trained and certified to carry out such activities.
Caution:
It is the responsibility of the installer to insure that when using the outdoor
antenna kits in the United States (or where FCC rules apply) only those
antennas certified with the product are used. The use of any antenna other
than those certified with the product is expressly forbidden in accordance to
FCC rules CFR47 part 15.204.
2.1
Preparing the Site
Carefully select and prepare each radio site to make device installation and
configuration as simple and trouble-free as possible. During site selection and
preparation, always consider the long-term needs of both your network and your
applications.
