6
Using the Utility
The following utilities are located on the "SIIG_SCSI" CD-ROM. If
you need further information on the bundled utilities, please refer
to the Anubis_Manual.pdf file.
a) Anubis Utility v3.07-A: This is a full featured utility that allows
you to format, partition, mount, and initialize SCSI devices.
b) Anubis Mounter v3.07-A: This utility allows you to mount,
unmount, and perform limited configurations on the selected
drive or bus.
c) Reader 3.1 Installer: This utility installs the Acrobat Reader.
Connecting External SCSI Devices
You can connect up to seven external SCSI devices to your
Fast SCSI Pro board.
NOTES
• Do not connect differential SCSI devices; use only
single-ended SCSI devices. (Unless specified, SCSI
devices you see in the store are all single-ended).
• It is important that you always use high-quality double
shielded twisted-pair external cable.
The combined length of all cables is limited to up to 6
meters (19.8 feet).
1.
Configure each SCSI device, such as a scanner or CD-R/RW
drive according to the manufacturer’s instructions.
a.
Follow the rules for terminating SCSI devices. The
Fast SCSI Pro and the last device connected on the
SCSI bus chain should be terminated.
b.
Verify that the default SCSI ID number set on each
device is unique. If there is a conflict, reset it to an
available ID (0-6, assuming board default of ID 7)
following by the manufacturer’s instructions.
2.
Attach one end of a SCSI cable to the external connector
on the Fast SCSI Pro and the other end to your SCSI
device.
Содержание SC2475
Страница 10: ...10...
