Signode TENSION-WELD VXT2-16, Руководство по эксплуатации, частям и безопасности

Страница: 5 / 36

5
PNEUMATIC INFORMATION
AIR PRESSURE REQUIREMENTS
The VXT2 tool is designed to operate at an air pressure of 90 psig (6.2 Bar).
AIR PRESSURE VS. PERFORMANCE
The air pressure supplied to the VXT2 tool must be a minimum of 85 psig (5.7 Bar) If the air
supply pressure can be adjusted within a range from 85 psi to 90 psi (5.7 - 6.2 Bar) the VXT2
tool's performance can be fine tuned to a particular application or operation preferences.
Changing the VXT2 air supply pressure to the tool will directly alter the rate at which the tool will
take-up the strap slack and the strap tension. Increasing or decreasing the VXT2 air supply
within the suggested 85 to 90 psig (5.7-6.2 Bar) range will not seriously affect the actual welding
portion of the strap cycle.
After an initial "Break-In" period, the air motor may become more powerful. If the tool's
performance is effected by this increase in performnace, reduce the air motor output by turning
the adjustment screw (Key 47 on the Air Motor Assembly) counter-clockwise as required.
AIR SUPPLY INSTALLATION
If compressor has a good dryer unit, use black pickled pipe. When a dryer unit is not installed,
use galvanized or copper pipe. To perform reliably, a pneumatic tool requires a continuous
source of clean, water-free air at adequate pressure.
Never operate this tool using a bottled air or gas source.
Bottled air/gas sources do not provide consistant operating pressure.
A filter-regulator-lubricator (FRL) unit must
be installed as close to the air tool as
possible, preferably within 10 feet. It should
be placed in a convenient location where it
can easily be drained, adjusted, and filled
with oil. The air hose must have at least a
3/8" I.D. A quick disconnect socket fitting is
installed on the stress spring end of the
hose for convenient hookup to the air tool.
Filter-Regulator-Lubricator Unit
(Signode Part No. 008559 or 173111)
FRL Mounting Bracket
(Signode Part No. 071982)
Air Hose, 3/8" ID, 1/4" Fittings
(Signode Part No. 008558)
Reducer Bushing, 3/8" to 1/4"
(Signode Part No. 008478)
Quick Disconnect, 1/4" Fitting
(Signode Part No. 020706)