3
Use the correct Signode products for your application. If you need help contact your
Signode Representative.
Signode tools and machines are designed and warranted to work together with Signode
strapping and seals. Use of non-Signode strap, seals and/or manufactured or specified
replacement parts may result in strap breakage or joint separation while applying strapping
to a load or during normal shipping and handling. This could result in severe personal
injury.
JOINT FORMATION
An improperly formed joint, or a joint with an incorrect number of notches, could result in strap
separation. Before moving any package, be certain that the joint is formed as shown in the
illustration. If not, remove the strap and check the tool for worn or broken parts. Repair the tool
before applying another strap. Failure to follow this procedure could
result in serious injury or death. If you have questions regarding proper
joint formation, contact your Signode Sales Representative.
Before making a double reverse notch seal joint, read the sealing tool’s
Operation. Parts and Safety Manual. A properly formed double reverse
notch joint will appear as shown in the illustration. More than one seal
may be required for your application. Always uses the correct number
of seals recommended by your Signode Sales Representative.
If the double reverse notch joint does not appear as shown in the
illustration proceed as follows:
1.
Review the tool’s operating instructions to be certain that the tool is being operated
properly before applying another strap.
2.
Cut the strap off, and apply a new strap and seal.
MOVING AND STACKING STRAPPED LOADS
Before moving or stacking any strapped load, follow all standard industry practices regarding
safe material handling procedures.
CUTTING TENSIONED STRAP
Using claw hammers, crowbars, chisels, axes or similar tools will cause tensioned strap to fly
apart with hazardous force. Use only cutters designed for cutting strap. Read the instructions in
the cutters manual for proper procedure in cutting strap. Before using any Signode product read
its Operation and Safety Manual.
TOOL CLEANING & LUBRICATION
Clean and apply a light weigth machine oil to all moving parts on a weekly basis. Clean the
feedwheel daily with a wire brush. Refer to the Pneumatic Information shown in this manual for
lubricant recommendations with regard to the air motor.
