9
OPERATING INSTRUCTIONS
Wear safety glasses which conform to ANSI Standard Z87.1 or EN 166.
Stand to one side of the strap while tensioning.
Make sure all bystanders are clear before proceeding.
Failure to follow the above could result in serious personal injury.
STRAP AND SEAL LOADING
Refer to the Specifications section to make sure the seal has been chosen. Insert the lead end of
the strap into the seal Signode No. 114P.
Pass the strap over the top of the package then bring the lead end around and up and rethread it
into the seal. This will result in creating a TOP STRAP and a BOTTOM STRAP. They will be
referred to later in these instructions.
Bend about 2 1/2" (63.5mm) of the lead end of the BOTTOM STRAP back beneath the seal to
maintain the loop. Refer to Figure 1 to make sure the loop has been properly formed. Hold the
BOTTOM STRAP and pull back on the TOP STRAP to draw loop loosely around the package. A
gentle upward bend on the TOP STRAP will hold the loop in place while the PRH2 tool is being
positioned.
