6
von 37
V 07.17
Service Manual BXT3-13/16/19
ENGLISH
Light applications
Average applications
Heavy applications
Number of strappings
- 1 to 100/day
100 to 500/day
> 500/day
Environment
–
Indoors
–
Clean surroundings
–
Room temperature
–
No contact with fluids
–
dry
–
No abrasive substances present
–
No corrosion vapours
–
Indoors
–
Industrial environment
–
Low temperature (<5°C) or strong
fluctuation
–
Increased humidity
–
No abrasive substances present
–
No corrosion vapours
–
Outdoors, covered
–
Industrial environment
–
Low temperature (<5°C) or strong fluctuation
–
Abrasive substances
–
High humidity
Typical sectors
–
General logistics
–
Paper industry
–
Cardboard box
–
Food
–
Panel wood
–
–
Construction industry (brick production, cement factories, etc.)
–
Sawmills
Recommended accessories
–
If required, hanging bracket
–
If required, hanging bracket
–
If required, second rechargeable battery
.
–
If required, hanging bracket
–
If required, second rechargeable battery
–
If required, optional protection plate set
–
If required, optional protection cover set
Special measures:
–
None
–
Avoid strong temperature fluctuations.
For example, when using in a refrige
-
rated warehouse, leave the device in the cold area, and remove the rechar
-
geable battery for charging at ambient temperatures.
–
Avoid strong temperature fluctuations. For example,
when using in a refrigerated warehouse, leave the device in the cold area, and remove the rechargea
-
ble battery for charging at ambient temperatures.
–
In wet areas, remove the battery from the tool as soon as it is no longer needed.
–
Dry the tool before the next use if it will be exposed to moisture at the next use.
Maintenance recommen
-
dations
(see also chapter
2.3)
–
Cleaning the tool as required (com
-
pressed air).
–
Lubricate the welding unit with grea
-
se every six months (see operating instructions, chap. 6.3.)
–
Every 2 years, service by a specialist unit.
–
Cleaning the tool as required (com
-
pressed air).
–
Lubricate the welding unit with grea
-
se every six months (see operating instructions, chap. 6.3.).
–
Annual service by specialist unit.
–
Cleaning the device as required (Caution!
Abrasive
dusts should not be blown into the tool using com
-
pressed air).
–
Lubricate the welding unit monthly with grease (see operating instructions, chap. 6.3).
–
Six-monthly service by specialist unit.
2.2
Maintenance requirements table
The workload and need for maintenance of the tool may vary strongly depending on the operating environment.
The required service work also dif
fers accordingly
. The table
below should provide a reference for categorising.
