Sigineer Power TPH 12KW, Руководство пользователя

Страница: 11 / 31

- 11 -
starts inverting and output goes to full voltage. When there is no load (or less than 25 watts) detected, the
inverter automatically goes back into search mode to minimize energy consumption from the battery bank.
In “Power saver on” mode, the inverter will draw power mainly in sensing moments, thus the idle
consumption is significantly reduced.
Power saver on Power saver off Power saver on (Load detected)
Note: The minimum power of load to take inverter out of sleep mode (Power Saver On) is 25 Watts.
Table 2.5.6 TPH Series Idle Power Consumption
Model
Power Saver Off Power Saver Auto
Idle(Max) 3Secs(Max) Stand-By Mode
1.0KW 18W 7.5W
2.5W
1.5KW 18W 7.5W
2.0KW 30W 10.0W
3.0KW 60W 15.0W
4.0KW 70W 20.0W
5.0KW 80W 25.0W
6.0KW 90W 25.0W
8.0KW 120W 30.0W
10.0KW 150W 35.0W
12.0KW 180W 40.0W
18KW 240W 60W
24KW 360W 80W
36KW 480W 120W
45KW 680W 150W
When in the search sense mode, the green power LED will blink and the inverter will make a ticking sound.
At full output voltage, the green power LED will light steadily and the inverter will make a steady humming
sound. When the inverter is used as an “Un-interruptible power supply” the search sense mode or “Power
Saver On” function should be defeated.
Exceptions
Some devices when scanned by the load sensor cannot be detected. Small fluorescent lights are the most
common example. (Try altering the plug polarity by turning the plug over.) Some computers and
sophisticated electronics have power supplies that do not present a load until line voltage is available. When
this occurs, each unit waits for the other to begin. To drive these loads either a small companion load must