-30-
2. Next, use the auger supplied with the heater to ream out the burner oil inlet hole in the base
of the burner. Later after the burner is reinstalled and before you replace the 1/4” clean out
plug, flush out the system by turning on the metering valve (carburetor) and letting some fuel
drip out the bottom.
3. There are four rows of holes in the side of the burner. These must all be clean. Use an
unbent paperclip (or the like )can also work. “Never! Never! Never! Enlarge or alter these
holes. Do not use a rag to wipe the inside of the burner, because you will be pushing carbon
into these holes. If needed, use a wire brush. Now replace the 1/4” clean out plug, be sure to
use some sealer and don’t over tighten. Replace the superheater. Be sure all four feet are flat
on the bottom of the burner base. Replace the burner ring. Note that the correct way is with the
disk down. Reconnect the fuel feed and overflow lines.
Cleaning Fuel Lines
Any blockage in the fuel line from the oil-metering valve to the burner can be cleaned by
removing the clean-out plug situated directly under the burner. The plug must be replaced
with tape sealant and checked for leaks. The fuel lines themselves can be cleaned with
compressed air or a pipe cleaner to remove any blockages. Tap the fuel line to relieve air
locks.
DO NOT OPERATE THIS PRODUCT UNATTENDED
Lighting Instructions
1. Remove top lid / open door
2. Turn the oil metering valve ON and allow about 30 ml (2 tbls) of fuel into the burner.
3. Turn the oil metering valve OFF
4. Open oven damper if applicable
5. Light the fuel with a twisted paper tissue
6. Replace lid / close door
7. Turn the fan assist to low speed
NOTE: If the flame should go out at this stage, do NOT relight for 10 minutes.
8. The fuel will vaporize in 5 to 10 minutes and when the flames go down in the burner
and start to go out: Turn the valve ON to a low setting that will keep the flames
burning above the burner ring.
9. When the flue pipe is hot(15 minutes of burning) the assist fan may be turned OFF or
on a very low setting.
10. Stay on low setting for 30 minutes before selecting higher settings
INCREASE FUEL SETTINGS IN VERY SMALL INCREMENTS
CAUTION: NEVER LIGHT A FLOODED BURNER
