Sierra Flame Lynwood W76, Инструкция по установке и эксплуатации

Страница: 8 / 31

Page 8
They are nationally recognized and are accepted by most local authorities. Your local dealer or
your local building official may have a copy of these regulations.
WARNING!
CHECK ALL LOCAL BUILDING AND SAFETY CODES BEFORE INSTALLATION.
THE INSTALLATION INSTRUCTIONS AND APPROPRIATE CODE REQUIRE-
MENTS MUST BE FOLLOWED EXACTLY AND WITHOUT COMPROMISE. AL-
TERATIONS TO THE STOVE ARE NOT ALLOWED. DO NOT CONNECT THE
STOVE TO A CHIMNEY SYSTEM SERVING ANOTHER STOVE, APPLIANCE OR
ANY AIR DISTRIBUTION DUCT. FAILURE TO FOLLOW THESE INSTRUCTIONS
WILL VOID THE MANUFACTURERS WARRANTY.
WARNING!
THE PROTECTIVE MATERIAL FOR TRANSPORT IS PLACED INSIDE YOUR
STOVE AND BETWEEN THE PLATES OF THE UPPER BAFFLE, REMOVE IT BE-
FORE INSTALLATION. YOU CAN REACH THEM FROM THE TOP OF THE COLLAR
THROUGH THE FRONT OPENING.
NOTE
If you plan to vent your stove into an existing masonry chimney, have the chimney inspected
by a local fire marshal or qualified installer. Remember that the chimney and its location on the
roof heavily influences the stoves performance. An oversized flue may not provide effective draft
and a flue liner may be required. (Observe draft requirements). Consult your dealer or qualified
installer before final selection is made.
You may wish to leave enough room between the stove and the wall to make cleaning easier.
Floor protection
If the stove is to be installed on a combustible floor, the stove must be placed on a noncombus -
tible hearth pad, which extends 8” ( 200 mm measured from the legs) beyond the stove sides
and back, and 18” (455 mm) measured from side and back panels to the front. The floor protec -
tion can be any noncombustible material that has a minimum R- value of 1.0 and listed to UL-
1618.
FRONT
Floor protection for Canada 18” (45 cm)
from unit to fr ont of floor p rotector - and
8” (20 cm) to the sides.
Floor Protector must be under connector
pipe and 2” (5 cm) to the side for a through
the wall configuration.
8”
8”
USA 16
Canada 18”
FLOOR PROTECTOR
8”