a
a
a
a
a
5
Alignment
Loud noise formation, intense vibrations and wandering may be due to incorrect
alignment!
Align washing machine with spirit level
1.
Loosen lock nut in a clockwise direction with a wrench.
2.
Change height by rotating the appliance feet.
Caution:
All four feet must be firmly on the floor.
The washing machine must not wobble!
Check alignment of the washing machine with a spirit level and, if
required, correct.
3.
Tighten the lock nut against the housing.
Grip the foot and do not adjust the height.
Caution:
The lock nuts on all four appliance feet must be screwed tightly
against the housing!
Electrical connection
ʑ
Connect the washing machine to an alternating current via a correctly installed
earthed socket only.
ʑ
The mains voltage and voltage specifications on the washing machine (appliance
rating plate on the rear of the appliance) must match.
ʑ
Connected load as well as required fuse are indicated on the appliance rating plate.
ʑ
Ensure that:
the mains plug and socket match,
the cable cross-section is adequate,
the earthing system has been installed correctly.
ʑ
A damaged power cord may be replaced by an electrician only.
A replacement mains cable can be obtained from customer service.
ʑ
Do not use multiple plugs/couplings or extension cables.
ʑ
In the event that an earth leakage circuit breaker is to be used, only use types
marked with the following symbol:
.
Only this symbol can guarantee compliance with all current regulations.
ʑ
Mains plug:
Do not insert/pull out with damp hands.
Do not pull by tugging the power cord.
Never pull it out during operation.
m
ax
. 1
2
m
m
6
Transportation, e.g. if moving house
1.
Before transporting the washing machine:
1.
Turn off the tap.
2.
Drain any residual washing solution.
a
Page 12
3.
Release the water pressure in the supply hose.
a
Page 12
4.
Isolate the washing machine from the power supply.
5.
Remove the hoses.
6.
Drain dispensers.
a
Page 8
2.
Installing transportation protection devices:
1.
Remove covers and keep
in a safe place.
If required, use a
screwdriver.
2.
Insert all 4 sleeves.
Clamp mains cable on the
holders. Insert and tighten
the bolts.
3.
Before switching on the appliance again,
remove the transportation protection devices!
a
Page 3
To prevent unused detergent from flowing into the outlet during the first wash: Pour 1 litre of
water into dispenser
B
/
C
and start the
Empty
programme.
Aqua-Stop warranty
For appliances with Aqua-Stop only
In addition to warranty claims against the seller based on the contract of sale and in addition
to our appliance warranty we shall pay damages under the following conditions:
1.
If water damage was caused by a fault in our Aqua-Stop system, we shall compensate private
users for damage.
2.
The liability warranty applies to the service life of the appliance.
3.
A claim can only be made under the warranty if the appliance and Aqua-Stop have been
correctly installed and connected according to our instructions; this also includes a correctly
installed Aqua-Stop extension (original accessory).
Our warranty does not apply to defective supply lines or fittings up to the Aqua-Stop
connection on the tap.
4.
Appliances which feature Aqua-Stop can be left unattended during operation and it is not
necessary to turn off the tap afterwards.
The tap should only be turned off if you are away for a prolonged period, e.g. several weeks
holiday.
ʑ
ʑ
ʑ
ʑ
a
