en
Faults and what to do about them.
50
Information on the display panel
Indicator/symbol
Cause/remedy
Œ
has lit up
■
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the washing
machine door immediately, if necessary. Press the
I
button to continue the
programme.
Œ
is flashing
■
Laundry may be caught. Open and close the door again and press the
I
button.
■
If necessary, push the door closed or remove the trapped laundry and then
push it closed again.
■
If necessary, switch the appliance off and on again; select a programme and
configure the settings; start the programme.
|
has lit up
■
Turn on the cold water tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter.
~
Page 48
w
The childproof lock is activated – deactivate it.
~
Page 40
:
the "Ready in" time
is flashing
The mains voltage is too low.
.
the "Ready in" time is
flashing
Undervoltage during the wash programme.
The length of the programme will be extended.
~
Page 42
E:18
■
The drain pump is blocked. Clean the drain pump.
~
Page 46
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~
Page 47
E:23
There is water in the base trough; the appliance is leaking. Turn off the tap. Call our
after-sales service.
E:32
is flashing alternately with
End
at the end of the programme.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Run the spin cycle
again, if necessary.
Other indicators/
symbols
Switch off the appliance, wait for 5 seconds and then switch it back on. If the
indicator/symbol appears again, call our after-sales service.
~
Page 53
Symbol in timeLight*
(display on the floor):
*Depends on the model
Cause/remedy
:
|
■
A fault has occurred
~
See "E" above: ...
■
See symbol above
