Programme default settings
en
35
0
Programme default
settings
Programme default settings
The default program settings are
displayed in the display panel after
selecting the program.
You can change the default settings.
To do this, repeatedly press the
corresponding button until the required
setting is displayed on the display
panel.
Note:
Pressing and holding the buttons
automatically runs through the setting
values until the last one. Then press the
button again and you will be able to
change the setting values again.
You can find an overview of all possible
program settings on the supplementary
sheet for the installation and operating
instructions.
Spin speed
(
0
, rpm
0
, Spin speed)
Depending on what stage the program
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the program.
Setting 0
: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting
- - -: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To continue/end the program
~
Page 41
The maximum speed that can be set
depends on the model and program
that has been selected.
Ready in
(
û
,
û
Finished in, Finish in, Ready in)
Before starting the program
, you can
preselect the program end ("Finish in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
1.
Select a program.
The program duration is displayed
for the selected program, e.g.
2:30
(hours:minutes).
2.
Press the
Ready in
button
repeatedly until the required number
of hours is displayed.
3.
Press the
I
button.
The program starts.
The selected number of hours (e.g.
8
h
) is shown in the display panel and
counts down until the wash program
starts. The duration of the program is
then displayed.
Note:
The length of the program is
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
■
Program settings,
■
Detergent dosage (additional rinse
cycles if required due to foaming),
■
Load size/type of textiles (water
absorption differs),
■
Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■
Fluctuations in power supply,
■
Water pressure (infeeding speed).
Following the start of the program
, you
can change the preselected number of
hours as follows:
1.
Press the
I
button.
2.
Use the
Ready in
button to change
the number of hours.
3.
Press the
I
button.
Following the start of the program
you
can add or remove laundry as required.
~
Page 40
