Siemens SINUMERIK 840D sl, Руководство по эксплуатации функций

Страница: 1953 / 2184

Detailed Description
2.9 Sum offsets and setup offsets
Basic logic functions: Tool Offset (W1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
165
Special points to be noted
If
TOWMCS
or
TOWWCS
is active, the following setting data does not affect the non-transformed
wear components:
SD42920 $SC_WEAR_SIGN_CUTPOS (Sign of wear for tools with cutting edge systems)
The following setting data also does not affect the non-transformed wear components in
case of
TOWWCS
:
SD42910 $SC_MIRROR_TOOL_WEAR (Sign change tool wear when mirroring)
In this case, a possibly active mirroring is already contained in the frame, which is referred to
for evaluating the wear components.
On a plane change, the assignment between the nontransformed wear components and the
geometry axes is retained, i.e., these are not interchanged as with other length components.
The assignment of components depends on the active plane for tool selection.
Example
Let's assume a milling tool is used where only the wear value $TC_DP12 assigned to length
L1 is not equal to zero.
If
G17
is active, this length is effective in the direction of the Z axis.
This measure always acts in the Z-direction also upon a plane change after the tool
selection, when
TOWMCS
or
TOWWCS
are active and the bit 1 is set in the setting data:
SD42935 $SC_WEAR_TRANSFORM (transformations for tool components)
If, for example,
G18
is active on tool selection, the component is always effective in the Y
direction instead.