Siemens Simotics SD 1LE7, Руководство по эксплуатации

Страница: 9 / 44

1LE7
A5E36065207, 04/2018
7
4.2 Observing the operating mode
Observe the machine's operating mode. Use a suitable control system to prevent overspeeds, thus protecting the machine
from damage.
4.3 Delivery
Checking the delivery for completeness
The drive systems are put together on an individual basis. When you take receipt of the delivery, please check immediately
whether the items delivered are in accordance with the accompanying documents. Siemens will not accept any claims
relating to items missing from the delivery and which are submitted at a later date.
● Report any apparent transport damage to the delivery agent immediately.
● Report any apparent defects/missing components to the appropriate SIEMENS office immediately.
Archive the safety and commissioning notes provided in the scope of delivery as well as the optionally available operating
instructions so that these documents are always easily accessible.
The rating plate optionally enclosed as a loose item with the delivery is provided to enable the motor data to be attached on
or near the machine or installation.
4.4 Transportation and storage
Observe the following when carrying out any work on the machine:
● Comply with the general safety instructions (Page 1)
● Comply with the applicable national and sector-specific regulations.
● When using the machine within the European Union, comply with the specifications laid down in EN 50110-1 regarding
safe operation of electrical equipment.
4.4.1 Requirements for safe lifting and transporting
Preconditions for safe lifting and transporting
If you do not transport or lift the machine in a position appropriate for its construction, the machine can tip, slip into the lifting
equipment or fall down. This can result in death, serious injury or material damage.
● Use only the load carrying device on the stator frame for lifting.
● Use the load carrying device appropriate for the machine position.
● Only use suitable rope guiding or spreading devices.
Center of gravity not centered
If the center of gravity of a load is not located centrally between the attachment points, the machine can tip over or slip out of
the lifting equipment and fall when it is being transported or lifted. This can result in death, serious injury or material damage.
● Comply with the handling instructions on the machine when transporting it.
● Be aware of the possibility of different loads on the sling ropes or lifting straps and the carrying capacity of the lifting
equipment.
● Always take account of the center of gravity when transporting or lifting the machine. If the center of gravity is not located
centrally between the attachment points, then position the hoisting hook above the center of gravity.
4.4.2 Transport
Risk of dropping and swinging when transported suspended
If you transport the motor suspended from cables or ropes, the cables or ropes can break, e.g. as a result of damage.
Further, if not adequately attached, the motor can swing. This can result in death, serious injury, or material damage.
● Use additional, suitable lifting equipment for transport and during installation.
● Two cables alone must be able to carry the complete load.
● Prevent the lifting equipment from sliding by appropriately securing it.