Siemens SIMOTICS FD 1MM1 Series, Инструкции по эксплуатации и монтажу

Страница: 16 / 178

2.3 Safe handling
Workplace safety depends on the attentiveness, care, and common sense of the personnel
who install, operate, and maintain the machine. In addition to the safety measures cited, as a
matter of principle, the use of caution is necessary when you are near the machine. Always pay
attention to your safety.
Also observe the following to prevent accidents:
● General safety regulations applicable in the country where the machine is deployed.
● Manufacturer-specific and application-specific regulations
● Special agreements made with the operator
● Separate safety instructions supplied with the machine
● Safety symbols and instructions on the machine and its packaging
Danger as a result of stationary parts under voltage (live parts)
Live parts represent a hazard. Touch protection against active (live) parts is no longer
guaranteed if covers are removed. The minimum clearance and creepage distances may be
violated when coming close to live parts. Touching or coming close to them can result in death,
serious injury or material damage.
● Ensure that all live parts are suitably covered.
● Switch off and disconnect the machine first if you want to remove covers. Observe the "5
safety rules".
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can result in death, serious injury or material
damage.
● Ensure that all rotating parts are reliably covered.
● Switch off and disconnect the machine first if you want to remove covers. Observe the "5
safety rules".
● Only remove covers when the rotating parts have come to a complete standstill.
Risk of burns due to hot surfaces
Individual machine parts can become hot in operation. Burns can result when coming into
contact with these parts.
● Never touch machine parts during operation.
● Allow the machine to cool before starting work on the machine.
● Check the temperature of parts before touching them. If required, wear suitable protective
equipment.
Safety information
2.3 Safe handling
SIMOTICS FD 1MM1
16
Operating Instructions 02/2019