Siemens Simatic series, Руководство по эксплуатации

Страница: 174 / 194

Technical support
A.3 RAID system and device startup
SIMATIC IPC547G
174
Operating Instructions, 04/2020, A5E49948632-AA
A.3 RAID system and device startup
Problem Cause Remedy
The RAID software reports
the following errors:
• The RAID plug-in failed
to load, because the
drive is not installed.
•
The Serial ATA plug-in
failed to load, because
the driver is not installed
correctly.
• The Intel
®
Storage Con-
sole was unable to load
a page for the following
reason:
–
A plug-in did not
provide a page for
the selected device
– A plug-in failed to
load
RAID is not activated The messages have no negative effect on the operation of the
device and can be ignored.
Acknowledge the messages.
RAID is activated Install the software again using the supplied "Documentation
and Drivers" DVD.
After changing the drive, the
system does not boot from
the RAID system
RAID system does not have
highest boot priority
BIOS setup, Boot menu:
• Permit RAID system in the boot priority
•
Give RAID system top boot priority
After changing the drive,
"Unused" is indicated for the
relevant SATA port
System was booted without
functioning drive. The re-
movable tray might not be
fully pushed in.
Reboot the system with a functioning hard disk.
Computer does not boot or
"Boot device not found" is
displayed
The boot medium is not
approved
Allow the boot device in the boot priority in the "Boot" menu of
the BIOS Setup.
The boot device is not in
first place of the boot priori-
ty in the BIOS setup
Change the boot priority of "Boot device" in the "Boot menu of
the BIOS Setup.
The boot data carrier is set
up with GPT and UEFI boot
is deactivated in the BIOS
setup
Activate UEFI boot in the BIOS Setup.
The startup of a Windows
operating system on a GPT
data carrier is aborted with
the following error mes-
sage:
"Status: 0xc0000225 Info:
The boot selection failed
because a required device
is inaccessible"
The boot parameters in the
boot loader file "BCD" are
incorrect or damaged.
Run "Startup and Repair" from Microsoft Windows:
1.
Insert the Recovery DVD into the optical drive.
2. Select the line with "UEFI" in front of the name of the opti-
cal drive.
3. Click "Next" in the language selection window.
4. In the following "Install Windows" dialog, click "Repair your
computer" or press the <R> key. The "System Recovery
Options" dialog appears. The system is checked for errors.
5. Next, click "Repair and restart".