Siemens SIMATIC PG 760 PII, Руководство пользователя

Страница: 61 / 120

5-7
PG 760 PII Programming Device
C79000-G7076-C766-01
A branch is made to the following submenu when you select this type of
menu option:
PhoenixBIOS Setup Utility
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Previous Values Sub-Menu
Type:
Cylinders: [Auto]
Heads:
Sectors:
Maximum Capacity:
Main Security Power Exit Advanced
Primary Master [3249MB]
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
[AUTO] (recommended)
Autotypes installed
IDE–devices
[USER]
Enter parameters of
IDE-devices installed
at this connection
[1-39]
Select predetermined type of
hard-disk drive
[ 10850]
[ 15]
[ 63]
5250MB
[16 Sectors]
[Enabled]
[Enabled]
[FPIO 4 / DMA 2]
Figure 5-3 Example: “Primary Master”
The parameters which you can select here are usually saved on the respective
IDE drive, and are read from the drive and entered into the form when you
select the option “Autodetect Hard Disk.”
If you select the option “Type” for a drive which does not exist, an abort is
executed after approximately one minute as a result of a timeout and the
existing entries remain unchanged. It is therefore only meaningful to carry
out an autodetect for interfaces to which drives are connected.
Under certain circumstances it may be necessary to deviate from the
proposed hard disk parameters. In this case, select the corresponding menu
option and then the desired value using the [+] and [–] keys. Enter “none” in
the option “Type” if no drive is connected, or a number from 1 to 39 if a
predefined type of hard disk is to be used.
Select “User” if you wish to define your own type of hard disk; you must
then additionally enter the hard disk-specific parameters in the options
“Cylinders,” “Heads,” “Sectors/Track,” “Write Precomp.”
Option “Primary /
Secondary”
Option “Type ”
Configuring the PG 760 PII