Siemens SIMATIC PG 760 PII, Руководство пользователя

Страница: 101 / 120

7-21
PG 760 PII Programming Device
C79000-G7076-C766-01
The procedure described below can be used to remove a disc from the
CD-ROM reader if the Open/Close button is disabled by software or a power
failure occurs. In this case the CD tray cannot be opened automatically.
1. Turn off the power to the CD-ROM reader (switch off your device if
necessary).
2. Insert a steel rod or a stiff paper clip (with a maximum diameter of 1.3
mm and a minimum length of 55 mm) into the emergency eject hole at
the front of the drive and push lightly. The CD tray is ejected by about
10 mm. Pull it all the way open by hand and lift the disc out carefully.
at least
55 mm in length
By pushing the Open/Close button the CD tray is smoothly opened. Place the
CD with the labeled side upward into the tray. Do not use the built-in clips.
The tray is closed automatically after a short push or after having pushed the
Open/Close button.
!
Caution
Risk of data loss and damage to the drive!
CD-ROM drives are sensitive to vibrations and shock. Any vibrations occuring
during operation can lead to damage to the drive or CD.
The PG 760 PII is equipped with additional slots for disk drives and
expansion modules. For further information refer to Chapter 4 of the manual.
The manual is available in electronic format on the back-up CD supplied.
Emergency Eject
Operating your
CD-ROM drive
Additional Slots
Hardware Information