Modules
4.2 Installing/Removing Line Modules
4. Pull the module from the chassis to disconnect it.
1
2
3
1
Chassis
2
Module
3
Screw
Figure 4.3
Removing a Module
5. Install a new module or a blank module (to prevent the ingress of dust and dirt).
6. [Optional] If necessary, install the device in the rack.
7. For control and switch modules only, connect power to the device.
Installing a Line Module
To install a line module, do the following:
1. For Control and switch modules only, make sure power to the device has been
disconnected and wait approximately two minutes for any remaining energy to
dissipate.
2. [Optional] If the device is installed in a rack, remove it from the rack.
3. Remove the current module from the slot.
RUGGEDCOM RX5000
Installation Manual, 01/2021, C79000-G8976-1058-13
29