Appendix
A.2 Configure "SetBrightness" function
MP 377 15" Touch daylight readable (WinCC flexible)
62
Operating Instructions (Compact), 04/2009, A5E02532357-01
A.2.2
Add-on "SetBrightness"
Introduction
This section describes the configuration of the function "SetBrightness" based on an
example, how to set the brightness of displays with a potentiomenter "externally" for a panel
and "centrally" in a control room. The following picture shows the structure of such a system.
%ULJKWQHVVYDOXH
352),1(7
352),%86
The following section describes how to configure "SetBrightness" function. It explains which
parameters are available and how you operate them. Please note the "Setting the display
brightness (Page 42)" chapter.
NOTICE
Project transfer to an MP 377 15" Touch daylight readable only
If the "SetBrightness" function is part of a project, then the project transfer can only take
place to an HMI device of the type "MP 377 15" Touch daylight readable".
Transfer to an HMI device of the type "MP 377" will fail.
Delete the "SetBrightness" function from the project before you transfer the project to an
HMI device of the type "MP 377".
Requirement
These are the requirements:
●
WinCC flexible 2008 is installed on a configuration computer.
●
The "SetBrightness" add-on is installed.
●
You have created a project.
