Parameter
Description
Range of values / note
a,b or a-b
or a,b,c-d
Number of a VLAN or VLAN range
enter a valid VLAN or VLAN
range
service
Specifies the services for which the manager is
authorized.
You can select several options.
●
snmp
●
telnet
●
http
●
https
●
ssh
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
The IP address 0.0.0.0 means "any manager"
If optional parameters are not specified when configuring, the following defaults apply:
● The manager is authorized for all services.
Note
Configuration of the first entry
As long as the list of authorized managers is empty, access to the system is not restricted.
As soon as the list contains an entry, access to the system is blocked for all others.
You should therefore configure the interface via which you access the system first because
your access is otherwise blocked.
Result
The interfaces and protocols via which an authorized manager is allowed to access the device
are configured.
Further notes
You delete an interface for access of an authorized manager with the
no authorized-
manager ip-source
command.
You show the information about the configuration of the authorized managers with the
show
authorized-manager
command.
11.6.2.2
no authorized-manager ip-source
Description
With this command, you delete an interface via which an authorized manager is allowed to
access the device.
Requirement
You are in the Global configuration mode.
Security and authentication
11.6 Management Access Control List
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
579